Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
- Suspension bracket and steering system
   Forward suspension bracket — the general information
   Removal and installation of an amortization rack
   Dismantling amortization rack/removal and shock-absorber installation / screw spring
   Shock-absorber check
   Removal and installation cross-section lever/replacement of a rubber support
   Check/replacement of a support of the cross-section lever / rotary fist
   Removal and installation of a power shaft
   Removal and installation of an intermediate shaft
   Check/dismantling driving shaft/replacement of cuffs
   Bearing of a forward nave
   Back suspension bracket
   Removal and installation of a back amortization rack
   Dismantling back amortization rack/removal and shock-absorber installation / screw spring
   Cross-section levers / longitudinal lever/stabilizer
   Check of the bearing of a nave
   Removal and installation of the bearing of a nave
   Adjustment люфта nave bearing
   Removal and nave installation
   Steering
   Removal and installation of a steering wheel
   Removal and installation of a tip of steering draft
   Removal and installation of a rubber cuff of a steering drive
   Servoupravleniye pump
   Corners of installation of wheels
   Values for MAZDA 323 check
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits




Back suspension bracket

The suspension bracket of a back wheel consists of the amortization rack, two bottom cross-section levers and a longitudinal bar. Both parties are connected by the stabilizer which reduces a body inclination at movement on turn.

Back bearings of naves the unattended. On cars to 9/89 g вып. it is regulated люфт the bearing, since 10/89 g вып. (except the versatile person models) the changed, noncontrollable bearings of naves are established.

On the MAZDA 323 models with a full drive for a drive of back wheels on a beam the differential from which two semi-axes to back wheels depart is fixed. For the rest the design of a back suspension bracket almost coincides with front-wheel models, differences at repair will be especially specified.

1 — a back amortization rack
2 — a longitudinal bar

3 — the stabilizer
4 — the cross-section lever (adjustable)