Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
- Suspension bracket and steering system
   Forward suspension bracket — the general information
   Removal and installation of an amortization rack
   Dismantling amortization rack/removal and shock-absorber installation / screw spring
   Shock-absorber check
   Removal and installation cross-section lever/replacement of a rubber support
   Check/replacement of a support of the cross-section lever / rotary fist
   Removal and installation of a power shaft
   Removal and installation of an intermediate shaft
   Check/dismantling driving shaft/replacement of cuffs
   Bearing of a forward nave
   Back suspension bracket
   Removal and installation of a back amortization rack
   Dismantling back amortization rack/removal and shock-absorber installation / screw spring
   Cross-section levers / longitudinal lever/stabilizer
   Check of the bearing of a nave
   Removal and installation of the bearing of a nave
   Adjustment люфта nave bearing
   Removal and nave installation
   Steering
   Removal and installation of a steering wheel
   Removal and installation of a tip of steering draft
   Removal and installation of a rubber cuff of a steering drive
   Servoupravleniye pump
   Corners of installation of wheels
   Values for MAZDA 323 check
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits



FIAT

Removal and installation of a rubber cuff of a steering drive

Removal

 PERFORMANCE ORDER

    To remove a tip of steering draft. To weaken collars on both ends of a cuff. To compress tightening collars flat-nose pliers, or to turn off wire collars.
    To remove a rubber cuff.

If the cuff was faulty already long time, it is possible to draw a conclusion that dirt got into the mechanism. Dirt together with greasing operates as shlifovochny paste and destroys the steering mechanism. In this case, and also at existence on a gear lath of traces of a rust, the steering mechanism is necessary for repairing (it is carried out in a workshop).

Installation

 PERFORMANCE ORDER

    Slightly to grease steering draft - With-.
    A few to grease a cuff - In - inside on a fillet - Е-and to pull on steering draft - With-. To pull a cuff on a case of a gear lath - And-.
    Two times to wrap up a new wire round a cuff on the steering mechanism and 4 - 4,5 times to braid. Instead it is possible to use also a standard shlangovy collar with a bolt.
    To fix a cuff on steering draft a wire collar.

The rubber cuff should not be overwound.

    To establish a tip of steering draft. To lower the car. To check a convergence, if necessary to adjust.