Mazda 323

since 1985 of release

Repair and car operation


Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
- Brake system
   Specifications of brake system
   Forward brake
   Removal and installation of forward brake shoes
   Check of thickness / lateral palpation of a brake disk
   Removal and installation of blocks of a back disk brake
   Removal and installation of a support of a brake
   Removal and installation of a brake disk
   Removal and installation of back brake blocks / brake drum
   Removal and installation of the wheel brake cylinder
   Repair of the wheel brake cylinder
   Brake liquid
   Pumping of brake system
   Replacement of brake pipelines and hoses
   Check of the brake amplifier
   Removal and installation of the switch of stoplights
   Hand brake
   Adjustment of the hand brake
   Anti-blocking system (ABS)
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits


BMW 7 - про автомобиль BMW 7

Removal and installation of a support of a brake

Removal

 PERFORMANCE ORDER

    To remove brake shoes. Only in case of disk back brakes: Completely to weaken a cable of the hand brake and to disconnect a cable from a support. If the support is necessary for removing completely, to unscrew a brake hose on a support.

Brake liquid will follow. It should be collected in specially intended bottle. After installation the brake system should be pumped over.

    If the brake hose remains is connected, to suspend the top part of a support for a wire to a body so that the brake hose was not overwound and was not tense.
    To unscrew a support from a rotary fist (2 bolts).

Installation

 PERFORMANCE ORDER

    To establish a support and to tighten both bolts of fastening with effort of 50 Nanometers.

If the brake hose was removed, to screw it. The brake hose at installation should not be overwound. To enclose new laying, to tighten a bolt with effort of 30 Nanometers.

    To establish brake shoes. If the system was opened, it is necessary to remove air from it, see. Section Pumping of brake system. For a back support: To attach a cable of the hand brake. To establish brake shoes, see the corresponding chapter.

Several times to squeeze out a brake pedal, notable resistance will not be felt yet. At the expense of it the adjusting device of the parking brake is established.

    Back disk brakes: To adjust the hand brake, see. Section Adjustment of the hand brake.