Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
- Wheels and tires, body, car coloring, care of the car
   The sizes of disks and tires/pressure in tires
   Designations of disks
   Designations of tires
   Replacement of wheels
   Rules of care of tires
   Balancing of wheels
   Antisliding chains
   Spare wheel
   Wear of tires
   Body
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal and front grille installation
   Removal and installation of lateral moldings
   Removal and installation of a forward wing
   Removal and cowl installation/adjustment
   Removal and installation/adjustment of a door of a back
   Removal and door installation/adjustment
   Upholstery door door/window regulator/glass
   Removal and installation of an upholstery of a door
   Removal and installation of a glass/window regulator of a forward door
   Lock/handle/cylinder of the lock of a door
   Lock of a door of a back / internal drive
   External mirror
   Removal and installation of glass of a mirror
   Panel of devices / average console
   Forward seats
   Removal and installation of a back seat
   Back seat
   Car coloring
   Elimination of damages from stones
   Rikhtovka body/repair of rusty openings
   Preparation for painting
   Coloring
   Wash of the car
   Care of a varnish covering
   Protection of the bottom and preservation of cavities
   Care of an upholstery
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits




Elimination of damages from stones

Regular elimination of small damages of paint of justifies, as thus it is possible to avoid distribution of a rust and larger repair work. At small scratches and traces from stones which mentioned only an external layer of coloring and did not get to naked metal, in general it is enough to tint by means of a varnish pencil. Along with paint which is put with a small brush, often there is useful a colored film available on sale if damage is absolutely insignificant or when it is necessary to put only a first coat.

 PERFORMANCE ORDER

    Deeper damages from blows of stones when small points of a rust were formed, act in film "an eraser for a rust" or are scratched out by a knife before emergence of naked metal. It is important, that it was not visible the smallest traces of a rust. Under "an eraser for a rust" the small plastic plug having for a vytsarapyvaniye of a rust a brush from a short wire means. Naked metal should be dried faultlessly up and fat-free. For this purpose to process a place of repair and a surrounding paint and varnish covering an udalitel of silicone. To put on naked metal with a thin brush of a little varnish first coat ("Primer"). As grounding means are available in aerosol packings more often, to sprinkle a little first coat on a cover banks and to dip there a brush. After drying of a layer of earth to make подкраску. In banks with paint the brush is built usually in a cover. If there is only an aerosol packing, to sprinkle a little paint on a cover banks and to dip there a brush for water color paints. Thus for each working pass to put only very thin paint coat that paint did not spread. In summary to give to paint it is good to dry. Process to repeat before filling of a crater and until there is imperceptible a deepening of a place of repair in relation to the surrounding painted surface.