Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
- Wheels and tires, body, car coloring, care of the car
   The sizes of disks and tires/pressure in tires
   Designations of disks
   Designations of tires
   Replacement of wheels
   Rules of care of tires
   Balancing of wheels
   Antisliding chains
   Spare wheel
   Wear of tires
   Body
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal and front grille installation
   Removal and installation of lateral moldings
   Removal and installation of a forward wing
   Removal and cowl installation/adjustment
   Removal and installation/adjustment of a door of a back
   Removal and door installation/adjustment
   Upholstery door door/window regulator/glass
   Removal and installation of an upholstery of a door
   Removal and installation of a glass/window regulator of a forward door
   Lock/handle/cylinder of the lock of a door
   Lock of a door of a back / internal drive
   External mirror
   Removal and installation of glass of a mirror
   Panel of devices / average console
   Forward seats
   Removal and installation of a back seat
   Back seat
   Car coloring
   Elimination of damages from stones
   Rikhtovka body/repair of rusty openings
   Preparation for painting
   Coloring
   Wash of the car
   Care of a varnish covering
   Protection of the bottom and preservation of cavities
   Care of an upholstery
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits




Rikhtovka body/repair of rusty openings

Small dents can be eliminated by means of a leveling hammer and the corresponding manual anvil, at openings from a rust on a body it is recommended depending on the amount of damage or to replace a body detail in a set, or to give a detail to tea leaves.

Rikhtovka

 PERFORMANCE ORDER

    Small dents to beat out a leveling hammer, holding thus from the opposite side a manual anvil. Not too strongly to knock, differently metal will be extended and will not get a smooth surface. To work evenly passing from edge to the middle of the damaged place.
    Constantly to feel a hand a prepared surface before acquisition of the necessary form by it. Small roughnesses are removed subsequently a shpatlevka. After a rikhtovka carefully to remove a rust and old paint. Or the rough emery paper (grain 120) which has been put on a wooden die, or the corresponding grinding sheets on the grinding circle, the decorative moldings located nearby and plastic details to close a protective film that on imprudence them not to scratch.