Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
- Electric equipment system
Search of malfunctions of electric system
Switch check on a current transmission
Relay check
Check of the motor of a screen wiper
Verification of indexes of turn
Check of stoplights
Check of a heater of back glass
Separation and connection of cable tips
Arrangement of safety locks
Replacement of safety locks
Removal and battery installation
Battery check
The battery is discharged in itself
Battery charging
Battery storage
Generator
Security measures for the generator of an alternating current
Check of tension of the generator
Removal and generator installation
Generator components
Dismantling generator/replacement of coal brushes
Removal and starter installation
Check/replacement of the traction relay of a starter
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits
|
Removal and battery installation
|
|
At shutdown of the battery data from memory of malfunctions of a monitor двигатея, anti-blocking system, and also other constantly working devices (for example, a radio receiver and hours) are erased. Before shutdown to consider data from memory of malfunctions. Some radio receivers have a protective code. The coding prevents unauthorized turning on of the receiver after food shutdown. A food is disconnected, for example, at battery shutdown, at removal of a radio receiver or at safety lock failure. If the radio receiver is coded, before shutdown to define a protective code. If the code is unknown, turn on the receiver the producer can only. |
Removal
|
|
To switch off ignition and illumination of the car. Thanks to it damages of electronic monitors (for example, an engine monitor) are prevented.
To open a cowl. The battery is in an impellent compartment on the left side.
|
|
To disconnect cables from the battery, at first a cable of weight-1-, then a plusovy cable-2-. Previously to remove a rubber cap-3-. Near poles of the battery the corresponding badges + are squeezed out and —.
|
To unscrew and take out a bracket of fastening-4-.
To take out the battery.
|
|
The battery contains poisonous substances therefore it should not jump out with household garbage. It is necessary to hand over old batteries in special points. |
|
|
Installation
|
|
Before installation to smooth out battery poles, the brush from a brass wire for this purpose approaches. For protection against corrosion to cover poles with special greasing, for example greasing for BOSCH poles.
To insert the battery.
To establish and slightly to screw a fastening bracket.
To connect a plusovy cable to a plusovy pole of the battery, a weight cable to a minus pole of the battery.
|
|
Incorrectly connected battery can lead to considerable damages of the generator and electric equipment. |
To put on a polymeric cap a plusovy pole.
If it is required, to program a radio receiver.
To establish time on hours.
|
|
|
|