Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
- Heater, lighting system, devices
   Heater
   Fan motor
   Removal and installation of the fan of a heater
   Control unit heater
   Adjustment of drives of a heater
   Check of the motor of fans/preresistors
   Check of the switch of a heater
   Lighting system
   Table of lamps
   Replacement of lamps of external lighting
   Headlight
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of back lamps
   Devices
   Instrument guard
   Removal and installation of an instrument guard
   Devices
   Removal and radio receiver installation
   Removal and installation of loudspeakers
   Removal and installation of the shtyrevy aerial
   Replacement of brushes of screen wipers
   Removal and installation/adjustment snuffled a stekloomyvatel
   Removal and installation of levers of a forward screen wiper
   Forward screen wiper
   Removal and installation of the motor of a forward screen wiper
   Back screen wiper
   Removal and installation of the motor of a back screen wiper
   Removal and installation of the lever of a back screen wiper
+ Governing bodies and operation receptions
+ Electric circuits



что такое sla, vk.

Heater, lighting system, devices

Heater

For heating fresh air is sucked in under a windscreen and via the fan arrives in car salon. Thus air passes through the case of a heater and is distributed by various zaslonka between separate nozzles. If the heater is established on "heat", the zaslonka of warm air and cold air opens passes through the heat exchanger and heats up hot cooling liquid. Proceeding air heats up from lamely the heat exchanger and then arrives in car salon. The heater is regulated only at the expense of amount of the air proceeding through the heat exchanger, cooling liquid constantly circulates in the heat exchanger. For strengthening of capacity of a heater the four-stage fan serves. That the fan worked at separate steps with various speed, preresistors are connected to it.

Resistors are on a payment of connection of the fan. At malfunction it is necessary to replace all payment. The fan and the case of a heater are in salon under the dashboard.

Special equipment: Conditioner

By means of the conditioner in salon it is possible to establish temperature below ambient temperature. At operation of the conditioner humidity of air in salon besides decreases. The compressor of the conditioner is put in action from the engine through maple a belt which should be checked and if necessary be replaced within maintenance, see. Section Technology of service, tools and workplace equipment. Repair work on the conditioner should be carried out in a specialized workshop.

Not to open a contour of a coolant of the conditioner, also not to carry out near its welding works as there is a danger of a trauma and threat to health because of an acting coolant.

Cars with 9/85 on 9/89 g вып.

1 — a lateral nozzle of a razmorazhivatel
2 — a lateral nozzle of ventilation
3 — the bottom nozzle of ventilation
4 — an average nozzle of ventilation
5 — the control unit

6 — the back channel of heating
7 — the fan block
8 — an average nozzle of a razmorazhivatel
9 — a heater box

MAZDA 323 from 10/89 g вып.

1 — a heater box the airdistributing case and the heat exchanger
2 — the fan Block the fan motor with preliminary resistors