Mazda 323

since 1985 of release

Repair and car operation


Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
- Governing bodies and operation receptions
   Before landing in the car
   Running in
   Keys
   Locks of doors
   The uniform (central) locking device (if is available)
   Protection against pranks of children (if is available, only on back doors)
   Electric window regulator (if is available)
   Back rotary glasses (on 3-door models)
   Seats
   Adjustment of height of a steering wheel (if is available)
   Seat belts (if is available)
   Door back/trunk lid
   Fuelling
   Mirrors
   Luggage belts
   Trunk lid (if is available)
   Spare wheel
   Dashboard
   - Steering wheel and gear shifting
      Lock of ignition and steering column
      Engine start
      Management of RKPP and transfer case
      Car operation with an automatic transmission
      Recommendations for economic operation
      Tempostat (switch of a mode of maintenance of constant speed)
      Lighting and light alarm system
      Screen wiper and stekloomyvatel
      Control panel
      Other devices and equipment
      Heater and ventilation
      The conditioner (if is available)
      Lamps of salon, luggage carrier and lamp for reading (if is available)
      The movable hatch (if is available)
      Start by pushing or towage
      Impellent compartment
+ Electric circuits



The conditioner (if is available)

Conditioner operation

 PERFORMANCE ORDER

    Close lateral deflectors of fresh air. Establish the lever of adjustment of temperature in a desirable position. Start the engine, press the switch of the conditioner and establish desirable number of turns of the fan. Adjustment for the maximum capacity of cooling. Type A — Shift the temperature lever completely to the left, establish the lever fresh / circulating air in a position «» and establish the switch of number of turns of the fan in situation 4. Type B — Press a key fresh / circulating air so that the indicator lit up, and establish the switch of number of turns of the fan in situation 4.

Conditioner switch

The conditioner joins and switched off by switch pressing.

Even if the conditioner is not used long time, it should be included for some minutes once a week to grease compressor details.

Type A

Type B

Instructions on conditioner operation

    If the car was left under direct beams of the sun, before turning on of the conditioner open a window so that warm air could leave. At a rain it is possible to avoid a zapotevaniye of glasses if to lower temperatures in salon by means of the conditioner. At slow trains in a dense transport stream the capacity of the conditioner is limited because of engine idling. In this case move on low transfer to improve conditioner capacity. In due time perform works on check and maintenance so that he was ready to work at any time.