Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
- Power supply system, carburetor, system of injection of fuel
Purity rules at work with a power supply system
Removal and sensor installation/check in a fuel tank
Removal and installation of a fuel tank
Removal and installation of the fuel pump
Removal and installation/check of the fuel pump
Removal and installation of the air filter
+ Carburettor
- System of injection of fuel
System of injection of fuel
Memory of malfunctions
Security measures at work with injection system
Idling check
Verification of the contents WITH
Check/adjustment of the sensor of a butterfly valve
Removal and installation/check of the sensor of temperature of cooling liquid
Check of gates of injection (injectors)
Removal and installation of gates of injection
Check of the fuel pump
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits
|
Check/adjustment of the sensor of a butterfly valve Cars with a mechanical transmission
The sensor of provisions of a butterfly valve should be checked, if the engine badly accepts gas, has unstable idling and does not reach the maximum capacity. The sensor of provisions of a butterfly valve should be checked also within maintenance.
Check
|
|
To disconnect the tip from the sensor of provisions of a butterfly valve.
|
|
To adjust by means of flat щупа distance between a persistent bolt of a butterfly valve and the persistent lever.
|
|
|
To connect an ohmmeter and to check current passing between plugs.
|
| Engine |
Thickness щупа |
Between contacts |
Current passing |
| yes |
no |
| В6 to 9/89 |
0,5 mm |
IDL — TL |
X |
|
| PSW — TL |
|
X |
| 0,7 mm |
IDL — TL |
|
X |
| PSW — TL |
|
X |
| VZ, В6 from 10/89 VR |
0,1 mm |
IDL — TL |
X |
|
| PSW — TL |
|
X |
| 1,0 mm |
IDL — TL |
|
X |
| PSW — TL |
|
X |
| In total |
Zaslonka of a throttle is completely open |
IDL — TL |
|
X |
| PSW — TL |
X |
|
If the result of one of these measurement does not correspond to demanded value, the sensor of provisions of a butterfly valve should be adjusted.
To connect the tip to the sensor.
|
|
Adjustment
|
|
To disconnect the tip of the sensor of provisions of a butterfly valve.
To connect an ohmmeter between TL and IDL contacts.
To adjust on the necessary size distance between the persistent screw of a butterfly valve and the persistent lever by means of flat щупа.
Demanded value: to 9/89 g вып.: 0,5 mm with 10/89: 0,4 mm
|
|
To weaken bolts of fastening of the sensor of provisions of a butterfly valve.
|
To turn the sensor on 30 ° to the right, and then slowly to turn back while the ohmmeter will not start to show current course.
To insert between the persistent screw of a butterfly valve and the persistent lever щуп in the thickness of 0,7 mm. Now on plugs the current should not proceed. If the current proceeds, adjustment should be repeated.
To tighten both bolts of fastening with effort of 2 Hм. | The sensor of provisions of a butterfly valve at a tightening of bolts should not turn. |
Several times completely to open a butterfly valve by means of a gas pedal.
Once again to check adjustment of the sensor of a butterfly valve.
|
|
|
|