Mazda 323

since 1985 of release

Repair and car operation


Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
- Coupling
   Removal and coupling installation/check
   Removal and installation/check of the vyzhimny bearing of coupling
   Adjustment of a pedal/cable of coupling
   Check/adjustment of a pedal of coupling
   Air removal from a coupling drive
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits



Adjustment of a pedal/cable of coupling

Front-wheel models with the petrol engine to 9/89 g вып.

The drive of coupling should be regulated after each repair of coupling, and also it is regular within maintenance. Adjustment should be checked also at difficulties of inclusion and coupling switching off.

Adjustment

 PERFORMANCE ORDER

    To measure pedal height from the top party of a pedal to a sexual rug. Demanded value: from 215 to 220 mm.
    For adjustment of height of a pedal to remove the bottom facing of the dashboard to reach an adjusting bolt. To adjust pedal height rotation of a persistent bolt, previously having weakened a lock-nut (a lock nut). On models with electronic system of injection instead of a persistent bolt the coupling switch is established. In this case to disconnect the tip and to adjust pedal height switch rotation. To measure a free wheeling of a pedal. For this purpose slightly to press a pedal a hand, considerable resistance will not be felt yet. Demanded value: from 9 to 15 mm.
    If the free wheeling of a pedal does not correspond to demanded limits, to open a cowl and to adjust a free wheeling an adjusting nut - In - on a carving element of a cable of coupling. Demanded value of a gap - And: from 1, 5 to 3, 0 mm (a gap between the lever of a transmission and a cable finger).
    After adjustment completely to squeeze out a pedal of coupling and to measure switching off height between an overlay of a pedal and a rug. Demanded value: at least 85 mm. Otherwise to repeat adjustment.