Mazda 323

since 1985 of release

Repair and car operation


Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
- Manual transmission
   Removal and transmission installation
   Gear shifting mechanism
   Full drive
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits



Gear shifting mechanism

1 — the handle of the lever of switching
2 — the average console
3 — a lateral wall
4 — a cuff of the lever of switching
5 — a bolt and a nut
6 — rubber fastening
7 — a spring
8 — the switching lever
9 — an upper berth of landing of a ball
10 — a casing
11 — the holder
12 — the bottom place of landing of a ball

13 — the plug
14 — draft of switching
15 — a being self-stopped nut (To tighten with effort of 10 Nanometers, always to replace.)
16 — rubber consolidation
17 — a nut and a washer
18 — the plug
19 — a remote element
20 — a lengthening bar
21 — a bolt and a nut
22 — the plug

 Gear shifting mechanism the unattended. The mechanism of switching of the car with a forward drive is represented.

On models with a full drive usual bars of switching replace two cables. It has that advantage that less place is required. At inclusion of transfers there is a distinction between cross-section movement (choice movement) in the provision of idling and actually switching. Both movements are transferred through the corresponding drafts to a transmission.

Removal

 PERFORMANCE ORDER

    To lift the car. To remove details in sequence of numbers.
    For removal of a spring-7-to take out a kryukoobrazny detail a screw-driver.

Installation

 PERFORMANCE ORDER

    Visually to check all details. Pognutye switching bars, worn-out hinges and the weakened springs to replace. All hinges and plugs before assembly to grease with universal greasing. To establish all details in sequence, return to removal. To fill a cavity of a support of the lever of switching with universal greasing.
    To screw drafts of switching for a transmission the every moment of an inhaling, see. Section Removal and transmission installation.