Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

- Introduction
   About this Management
   Mazda-323 brand cars — the introduction
   Identification numbers of the car
   Acquisition of spare parts
   Technology of service, tools and workplace equipment
   Engine start from an auxiliary source
   Poddomkrachivaniye and towage
   Automobile himikaliya, oils and greasings
   Diagnostics of malfunctions
   Routine maintenance
   + Works on maintenance
   + Box transfers/drive of wheels
   + brakes/tyres/wheels
   + Steering management/drive of forward wheels
   + car Electric equipment
   - Body / internal equipment
      Visual check of a bottom/body
      Greasing of locks
      Visual check of all seat belts
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits






Visual check of all seat belts

Noise at a pulling of a belt is caused functionally. At unusual noise it is possible to replace a seat belt only. By no means oil or greasing should not be applied to elimination of noise. Automatic equipment should not understand, as the compressed spring thus can jump out. Danger of accident.


 PERFORMANCE ORDER

  1. Completely to extend a seat belt and to check on existence of break of fibers. Damages can arise because of a jamming of a belt or a burning cigaret. In this case it is necessary to replace a belt.
  2. In the presence of shabby places, and fibers are not broken off, it is not required to replace a seat belt.
  3. To check a belt with a heavy course, whether it is overwound, if necessary to remove a casing on an average rack of a body.
  4. If automatic equipment of a belt does not work, it is necessary to replace a belt.
  5. To clear belts only soap and water, not to apply at all solvents or chemical cleaners.