Mazda 323
+ Introduction
+ Petrol engines
- System of greasing of the engine
Oil contour
Check of pressure of oil
Check of the sensor of pressure of oil
Removal and installation of the pallet of a case
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits
|
Check of pressure of oil Petrol engine
|
|
To check oil level.
To warm up the engine, the temperature of oil should be at least +80°С. This temperature is reached in normal conditions a trip on 15 km.
Injector engine: To unscrew fastening of an inlet collector.
To disconnect a cable from the sensor of pressure of oil and to unscrew the sensor. To collect following oil.
To screw in instead of the pressure sensor a suitable manometer.
|
|
To start the engine, to establish to work with verifying number of turns and to take readings.
|
To unscrew a manometer.
To cover 2-3 rounds of a carving of the sensor of pressure of oil with hermetic, for example, Loctite 242 to insert and screw the sensor with effort of 15 Nanometers. | Injector engine: To establish fastening of an inlet collector and to screw with effort of 25 Nanometers and 45 Nanometers.
|
|
|
Table of pressure of oil
| Engine |
Pressure of oil in the Bar |
Verifying number of turns |
| Petrol engine |
2,0 — 3,0
3,0 — 4,0 |
1000 rpm
3000 rpm |
| Diesel engine |
minute 3,0 |
3000 rpm |
Diesel engine
|
|
|
|
To unscrew an oil hose on the vacuum pump. To collect following oil.
|
|
|
To screw in a suitable manometer with a splitter in the pipeline.
|
To start the engine, to leave to work with verifying number of turns and to take readings.
To remove a manometer and a splitter and to screw an oil hose on the vacuum pump.
If pressure of oil does not correspond to demanded value, see the table.
|
|
|
|