Mazda 323

since 1985 of release

Repair and car operation


Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
- Ignition system
   Security measures at work with electronic system of ignition
   Check of the coil of ignition
   Check of a cable of ignition
   Check/adjustment of the moment of ignition
   Removal and installation of the distributor of ignition
   Spark plugs
   Candles for MAZDA 323
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits



Security measures at work with electronic system of ignition

In electronic system of ignition of MAZDA 323 tension of ignition can reach 30 quarter. Under adverse circumstances, for example humidity in an impellent compartment, peaks of tension can punch isolation and at a touch to cause shock. In order to avoid traumas and damages of system of ignition, at works it is necessary to consider the following:

    Not to touch by a hand and not to disconnect an ignition cable on the working engine or at a crankshaft provorachivaniye a starter. To disconnect wires of system of ignition only at the switched-off ignition. It is impossible to connect the condenser to mass of the coil of ignition for suppression of a radio noise or the tension indicator. To connect and disconnect measuring devices only at the switched-off ignition. It is impossible to replace the coil of ignition with other execution. By no means it is impossible to establish the coil of ignition intended for system with the breaker. When heating more than on 80°С (for example when painting) the engine cannot be started directly after heating. Wash of the engine to make only on the idle engine. At works as spot or electric welding the battery should be disconnected in a set. It is forbidden to perform works on ignition system to persons with an electropacemaker.