Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
- Ignition system
Security measures at work with electronic system of ignition
Check of the coil of ignition
Check of a cable of ignition
Check/adjustment of the moment of ignition
Removal and installation of the distributor of ignition
Spark plugs
Candles for MAZDA 323
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits
|
Removal and installation of the distributor of ignition The distributor of ignition is put in action directly from a cam-shaft. It is on a head of cylinders from a flywheel.
Removal
|
|
To disconnect a weight cable from the battery.
|
|
If is available, to disconnect the vacuum pipeline-1-from the ignition distributor.
|
To unscrew 2 bolts of fastening and to put aside a distributor-4-cover complete with cables of ignition-2-.
To disconnect the tip-3-.
To unscrew bolts of fastening of the distributor of ignition.
To take out the distributor from a head of cylinders.
|
|
Installation
|
|
To check an epiploon on the basis of the distributor on existence of damages.
To grease an epiploon with engine oil.
|
|
To 9/89 g вып.
|
|
To establish the piston of the 1st cylinder in the provision of ignition
|
|
To insert the distributor, thus marked party of a bracket on a shaft of the distributor should coincide with a label on the distributor case.
|
To establish bolts of fastening and to screw the distributor.
|
|
From 10/89 g вып.
|
|
To insert the distributor, thus to watch, that capture on the distributor was included into a groove on a cam-shaft. For this purpose slightly to press the distributor in an opening and at the same time to turn a shaft with a distributor rotor while it will not be latched and a rotor will not cease to rotate. | Capture of the distributor can is in a cam-shaft groove only in one situation. |
To level the distributor so that carving openings stood in the middle of longitudinal openings. To establish bolts of fastening and to tighten with effort of 25 Nanometers.
To clear a distributor cover from within, to check on existence of cracks and deposit traces, if necessary to replace.
To put on a cover of the distributor and to screw 2 bolts.
To put on the tip.
If it was removed, to connect the vacuum pipeline to the vacuum device of the distributor.
To connect a cable of weight of the battery.
If are available, to establish time on hours and to set a protective code of a radio receiver.
To check the ignition moment, if necessary to adjust.
|
|
|
|