Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
- Coupling
Removal and coupling installation/check
Removal and installation/check of the vyzhimny bearing of coupling
Adjustment of a pedal/cable of coupling
Check/adjustment of a pedal of coupling
Air removal from a coupling drive
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits
|
Removal and installation/check of the vyzhimny bearing of coupling Removal
|
|
To remove a transmission.
|
|
Cars to 9/89 g вып. and models versatile person: To disconnect a returnable spring of the lever of switching off of coupling on a case of a transmission and to remove vyzhimny the bearing from a fork of switching off of coupling.
|
|
|
Cars from 10/89 g вып., except models the versatile person: To remove vyzhimny the bearing together with a fork of switching off of coupling and then to remove the bearing. On all-wheel drive models from 1/90 g вып. to consider the adjusting provision of intermediate plates, see an illustration.
|
|
|
Check
|
|
|
|
To compress vyzhimny the bearing and at the same time to turn. On cars from 9/89 g вып. the bearing to stretch and at the same time to turn. If the bearing rotates hardly, to establish the new bearing. |
| The bearing has long-term greasing and should not neither be cleared, nor be greased. |
|
|
Installation
|
|
|
|
Slightly to grease prileganiye surfaces on the vyzhimny bearing and a fork of switching off of coupling with MoS2 greasing.
|
|
|
To attach vyzhimny the bearing to a fork and to insert both elements on a transmission shaft.
|
|
|
|
|
On all-wheel drive models from 1/90 g вып. between a fork of switching off of coupling and the vyzhimny bearing there is a needle bearing which facilitates coupling reduction in action. Before installation of the new vyzhimny bearing to rearrange both intermediate plates with a spring from the old bearing on the new. |
|
To attach a casing of a fork of switching off of coupling on a transmission case.
If is available, to attach a returnable spring of the lever of switching off of coupling.
|
|
|
|