Mazda 323

since 1985 of release

Repair and car operation


Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
- Coupling
   Removal and coupling installation/check
   Removal and installation/check of the vyzhimny bearing of coupling
   Adjustment of a pedal/cable of coupling
   Check/adjustment of a pedal of coupling
   Air removal from a coupling drive
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits



Check/adjustment of a pedal of coupling

Hydraulic drive (all models, except "versatile person" and front-wheel with the petrol engine to 9/89 g вып.)

The height and люфт should be checked pedals of coupling at emergence of difficulties of inclusion and switching off, and also after removal of the switch of coupling. The switch of coupling is on the block of pedals and reports to a monitor of system of injection about impact on a coupling pedal. On the diesel engine instead of the switch the persistent bolt is screwed in.

Check/adjustment of height of a pedal

 PERFORMANCE ORDER

    To measure distance from the top party of a pedal to a rug. Demanded value: Models from 10/89 g вып.: 196-204 mm; diesel models, and also all-wheel drive to 9/89 g вып.: 229-234 mm.
    If necessary to remove the bottom facing of the dashboard, to reach the adjusting screw. To disconnect the tip from the coupling switch - In - to weaken a lock-nut - And - and to adjust pedal height switch rotation. To tighten a lock-nut with effort of 15 Nanometers. After this adjustment it is necessary to check люфт pedals.

Check/adjustment люфта coupling pedals

 PERFORMANCE ORDER

    To press a pedal of coupling by a finger, notable resistance will not be felt yet. To measure люфт pedals. Demanded value: from 5 to 13 mm. Instruction: By pressing through 0,7 - 3,3 mm should be felt easy resistance. It is a point when the bar of a pusher concerns the piston of the main cylinder. If it is required, to weaken a lock-nut - With - and to adjust люфт pedals rotation of a rod of the piston - D-. Completely to squeeze out a pedal and to measure remained from a pedal to a rug distance. Demanded value: Models from 9/89 g вып.: at least 41 mm; diesel models, and also all-wheel drive models to 9/89 g вып.: at least 82 mm. To tighten a lock-nut - With - with effort of 15 Nanometers. After adjustment люфта pedals once again to check pedal height. To connect the tip to the switch of coupling and to establish dashboard facing.