Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
- Heater, lighting system, devices
Heater
Fan motor
Removal and installation of the fan of a heater
Control unit heater
Adjustment of drives of a heater
Check of the motor of fans/preresistors
Check of the switch of a heater
Lighting system
Table of lamps
Replacement of lamps of external lighting
Headlight
Removal and headlight installation
Adjustment of headlights
Removal and installation of back lamps
Devices
Instrument guard
Removal and installation of an instrument guard
Devices
Removal and radio receiver installation
Removal and installation of loudspeakers
Removal and installation of the shtyrevy aerial
Replacement of brushes of screen wipers
Removal and installation/adjustment snuffled a stekloomyvatel
Removal and installation of levers of a forward screen wiper
Forward screen wiper
Removal and installation of the motor of a forward screen wiper
Back screen wiper
Removal and installation of the motor of a back screen wiper
Removal and installation of the lever of a back screen wiper
+ Governing bodies and operation receptions
+ Electric circuits
|
Adjustment of headlights The correct adjustment of headlights is of great importance for safety of traffic. Exact adjustment is possible only by means of the special device. Therefore only the adjustment and condition places necessary for exact adjustment of headlights below are described.
|
|
In tires there should be an ordered pressure.
The driver's seat of not loaded car should be loaded with mass of 75 kg (one person), the fuel tank should be full. In summary to give a ride to the car some meters that springs were correctly established.
To establish the car on an equal surface.
To establish adjustment of range of light on "0".
Headlights should be regulated only at the included passing beam. The size of an inclination of a ray of light for normal headlights makes 12 cm on 10 m of distance, for fog lights of 20 cm on 10 m of distance.
The left headlights are represented; on the right screws are located specularly. The krestovy screw-driver is necessary for adjustment.
|
|
|
|