Mazda 323
+ Introduction + Petrol engines + System of greasing of the engine + System of cooling of the engine + ignition System + Power supply system, carburetor, system of injection of fuel + Diesel engine + System of production of the fulfilled gases + Coupling + Manual transmission + Automatic transmission + Suspension bracket and steering system + Brake system + Wheels and tires, body, car coloring, care of the car + electric equipment System - Heater, lighting system, devices Heater Fan motor Removal and installation of the fan of a heater Control unit heater Adjustment of drives of a heater Check of the motor of fans/preresistors Check of the switch of a heater Lighting system Table of lamps Replacement of lamps of external lighting Headlight Removal and headlight installation Adjustment of headlights Removal and installation of back lamps Devices Instrument guard Removal and installation of an instrument guard Devices Removal and radio receiver installation Removal and installation of loudspeakers Removal and installation of the shtyrevy aerial Replacement of brushes of screen wipers Removal and installation/adjustment snuffled a stekloomyvatel Removal and installation of levers of a forward screen wiper Forward screen wiper Removal and installation of the motor of a forward screen wiper Back screen wiper Removal and installation of the motor of a back screen wiper Removal and installation of the lever of a back screen wiper + Governing bodies and operation receptions + Electric circuits
|
Removal and installation of the motor of a back screen wiper Removal
|
To disconnect a weight cable from the battery.
To remove the bottom upholstery of a door of a back.
To remove the screen wiper lever.
To remove a sealing cap, to unscrew and remove the external plug.
To disconnect from the motor the multicontact tip.
To unscrew the motor from a body, for this purpose to turn out 4 bolts.
|
|
Installation
|
At installation of the new motor of its steklochistitel it is necessary to bring into final situation at first. For this purpose to connect the tip and let's work to the motor about 1 minute. Then to switch off the motor the switch and let's be established in final situation. To disconnect the tip.
To screw the motor on a back door with effort of 10 Nanometers.
To establish the external plug, to tighten a nut with effort of 5 Nanometers.
To put on a sealing cap.
To establish the screen wiper lever.
To connect to the motor the tip.
To connect a weight cable to the battery.
To check screen wiper work.
If are available, to establish time on hours and to set a protective code of a radio receiver.
To establish the bottom upholstery of a door of a back.
|
|
|
|