Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
- Heater, lighting system, devices
   Heater
   Fan motor
   Removal and installation of the fan of a heater
   Control unit heater
   Adjustment of drives of a heater
   Check of the motor of fans/preresistors
   Check of the switch of a heater
   Lighting system
   Table of lamps
   Replacement of lamps of external lighting
   Headlight
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of back lamps
   Devices
   Instrument guard
   Removal and installation of an instrument guard
   Devices
   Removal and radio receiver installation
   Removal and installation of loudspeakers
   Removal and installation of the shtyrevy aerial
   Replacement of brushes of screen wipers
   Removal and installation/adjustment snuffled a stekloomyvatel
   Removal and installation of levers of a forward screen wiper
   Forward screen wiper
   Removal and installation of the motor of a forward screen wiper
   Back screen wiper
   Removal and installation of the motor of a back screen wiper
   Removal and installation of the lever of a back screen wiper
+ Governing bodies and operation receptions
+ Electric circuits






Lighting system

Into system of lighting enter: main headlights, back lamps, stoplights, backing lamps, lamps of illumination of registration plate, turn indexes, back antifog lamps, illumination of salon. Illumination of devices will be considered in the Section Devices.

Filament lamps are subject to wear. They should be replaced each 2 years even if they are still serviceable. It does not belong to lamps Н4 (halogen lamps) main headlights, they remain much more long and are replaced only in case of failure. The lamp with the weakened brightness comes to light on a black raid on a glass flask. Before replacement of a lamp to switch off the switch of the corresponding consumer.

Not to undertake lamp glass fingers. Fingerprints black out a lamp and because of heat leave a sediment on a reflector. It is obligatory to use a lamp of the same execution. In the presence of spots on glass of a lamp to remove them with a rag with alcohol.