Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
- Heater, lighting system, devices
Heater
Fan motor
Removal and installation of the fan of a heater
Control unit heater
Adjustment of drives of a heater
Check of the motor of fans/preresistors
Check of the switch of a heater
Lighting system
Table of lamps
Replacement of lamps of external lighting
Headlight
Removal and headlight installation
Adjustment of headlights
Removal and installation of back lamps
Devices
Instrument guard
Removal and installation of an instrument guard
Devices
Removal and radio receiver installation
Removal and installation of loudspeakers
Removal and installation of the shtyrevy aerial
Replacement of brushes of screen wipers
Removal and installation/adjustment snuffled a stekloomyvatel
Removal and installation of levers of a forward screen wiper
Forward screen wiper
Removal and installation of the motor of a forward screen wiper
Back screen wiper
Removal and installation of the motor of a back screen wiper
Removal and installation of the lever of a back screen wiper
+ Governing bodies and operation receptions
+ Electric circuits
|
Removal and installation of levers of a forward screen wiper Removal
|
|
To disconnect a weight cable from the battery.
To mark the provision of screen wipers on glass with a sticky tape that it was possible to establish them in former situation.
To unscrew levers and to remove from axes, previously having removed caps with a narrow screw-driver.
|
|
Installation
|
|
|
|
To put on levers in final situation axes of a screen wiper and to screw with effort of 15 Nanometers. Screen wipers should be in final situation at distance of 28-32 mm from a final surface of a decorative slip or an air inlet lattice.
|
To establish on a screen wiper axis caps.
To connect a weight cable to the battery.
To check work of screen wipers.
If are available, to establish time on hours and to set a protective code of a radio receiver.
|
|
|
|
