Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
- System of cooling of the engine
Contour of cooling liquid
Antifrizny concentrate
Replacement of cooling liquid
Check of tightness of system of cooling
Removal and thermostat installation/check
Removal and installation of the water pump
Removal and radiator installation
Removal and installation of the motor of the fan
Thermoswitch check
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits
|
Replacement of cooling liquid Within maintenance cooling liquid should be replaced regularly, see. Head Introduction. | If cooling liquid merges within repair, it should be collected, as it contains antifrizny and anticorrosive means. At replacement of the water pump, a radiator or a head of cylinders it is necessary to replace cooling liquid surely. To apply only firm liquid on an etilenglikolevy basis. The concentrate should be coordinated with aluminum elements. It is impossible to apply cooling liquid on a spirit basis. |
Plums
|
|
To unscrew a cover on a radiator. | To uncover only if the radiator is cooled to temperature of hands, differently there is a danger to be scalded by hot cooling liquid. For safety to lay round the union a rag. |
To substitute under a radiator pure capacity for collecting liquid.
|
|
To merge cooling liquid from the radiator crane.
|
Let's to cooling liquid flow down completely.
To rinse system pure water while in water pollution will not disappear.
To screw in a drain stopper on a radiator.
|
|
Filling
|
|
To fill in cooling liquid through a radiator branch pipe.
To fill in cooling liquid in a broad tank to FULL mark. To establish a cover.
To start the engine and let's work 10 minutes on the raised turns. The engine should reach working temperature, the fan of a radiator should turn on. During warming up to watch liquid level, if necessary to add.
After cooling of the engine to check liquid level in a broad tank. If it is required, to add liquid to "FULL" mark.
To check tightness of system of cooling, especially connections of hoses and a drain stopper, and also the water pump.
|
|
|
|
