Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
- Diesel engine
   Principle of operation of the diesel engine
   Removal and installation gear belt/adjustment of a drive of the distributive mechanism
   System of preheat of the diesel engine
   Check of system of preheat
   Air removal from a power supply system
   Check/replacement of the electromagnetic valve of interruption of supply of fuel
   Adjustment of a drive of gas
   Check/adjustment of number of turns of idling
   Removal and installation of nozzles
   Removal and installation of the vacuum pump
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits






Removal and installation of the vacuum pump

The vacuum pump develops the low pressure necessary for operation of the brake amplifier.

The vacuum pump is on a reverse side of the generator. It is actuated from a generator shaft through a conducted disk.

Removal

 PERFORMANCE ORDER

  1. To remove the vacuum pipeline, previously having weakened a collar.
  2. To unscrew submitting oil pipeline. To disconnect a returnable oil pipeline, having weakened previously a collar.
  1. To unscrew bolts of fastening of the vacuum pump and to remove the pump about consolidation of round section.

Installation

 PERFORMANCE ORDER

  1. To check consolidation of round section of the vacuum pump on existence of damages, if necessary to replace.
  2. To establish the vacuum pump with consolidation and to tighten fastening bolts with effort of 7 Nanometers.
  3. To pour in an opening of the vacuum pump of a little engine oil.
  4. To put on a returnable oil pipeline and to fix a collar.
  5. To establish and tighten submitting oil pipeline.
  6. To establish the vacuum pipeline and to fix a collar.