Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
- Diesel engine
   Principle of operation of the diesel engine
   Removal and installation gear belt/adjustment of a drive of the distributive mechanism
   System of preheat of the diesel engine
   Check of system of preheat
   Air removal from a power supply system
   Check/replacement of the electromagnetic valve of interruption of supply of fuel
   Adjustment of a drive of gas
   Check/adjustment of number of turns of idling
   Removal and installation of nozzles
   Removal and installation of the vacuum pump
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits






Air removal from a power supply system

 PERFORMANCE ORDER

  1. When opening system or a full devastation of a fuel tank always it is necessary to delete air from a power supply system.
  1. To be convinced that in a tank there is a fuel.
  1. To open the gate of removal of air on the fuel filter.
  2. To pump up the manual pump fuel from a tank. The pump is on the top part of the filter.
  3. To pump over until in the fuel leaving the gate of pumping, air vials will not disappear.
  4. At the pressed manual pump to close the pumping gate.
  5. To pump over the manual pump (about 15 times) while by pressing resistance will not be felt.
  1. If the engine is not started because of emergence in pipelines of injection of an air stopper, to weaken cap nuts on nozzles and to include a starter that there was a fuel. Then to tighten nuts again and to start the engine.

To watch, that diesel fuel did not get on hoses of cooling liquid. If necessary it is necessary to clear hoses at once. It is necessary to replace the corroded hoses.