Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
- Diesel engine
   Principle of operation of the diesel engine
   Removal and installation gear belt/adjustment of a drive of the distributive mechanism
   System of preheat of the diesel engine
   Check of system of preheat
   Air removal from a power supply system
   Check/replacement of the electromagnetic valve of interruption of supply of fuel
   Adjustment of a drive of gas
   Check/adjustment of number of turns of idling
   Removal and installation of nozzles
   Removal and installation of the vacuum pump
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits






Check/replacement of the electromagnetic valve of interruption of supply of fuel

The electromagnetic valve on TNVD opens the fuel channel at ignition inclusion. It should be checked, if the engine is not started or continues to work after ignition switching off.

 PERFORMANCE ORDER

  1. To switch on and off ignition. The electromagnetic valve should click thus is distinguishable aurally.
  1. If the valve does not click, to check the voltmeter, whether tension is put to it at the included ignition. Ate tension it is not put, to find and eliminate wire break according to the scheme.
  2. If malfunction is not found, to disconnect a cable and to unscrew the valve.
  3. For a vyvinchivaniye of the valve to disconnect топливопровод from TNVD, previously having weakened a collar.
  4. To disconnect a gas drive.
  5. To connect to the removed electromagnetic valve the power supply 12 V.Sterzhen's tension of the valve it should be involved, otherwise replace the valve.
  6. To insert the new valve with laying and to tighten with effort of 25 Nanometers. To connect to the valve a cable.
  7. To connect топливопровод and to fix it a collar.
  8. To attach and adjust a gas drive.
  9. To remove from a power supply system air.