Mazda 323

since 1985 of release

Repair and car operation

Mazda 323

- Introduction
   About this Management
   Mazda-323 brand cars — the introduction
   Identification numbers of the car
   Acquisition of spare parts
   Technology of service, tools and workplace equipment
   Engine start from an auxiliary source
   Poddomkrachivaniye and towage
   Automobile himikaliya, oils and greasings
   Diagnostics of malfunctions
   Routine maintenance
   + Works on maintenance
   - Box transfers/drive of wheels
      Visual check of tightness
      Mechanical transmission: Check of level of oil
      Mechanical transmission: Oil replacement
      Automatic transmission: Check of level of oil
      Box of differential and transfer case: Check of level of oil
      Box of differential and transfer case: Oil replacement
      Check of rubber cuffs of power shafts
      Check of level of liquid of a drive of coupling
      Check/adjustment of a pedal of coupling
   + brakes/tyres/wheels
   + Steering management/drive of forward wheels
   + car Electric equipment
   + Body / internal equipment
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits

купить сварочный робот

Automatic transmission: Check of level of oil

The following spare parts are necessary:

    ATF Dexron - II or M - III



    To warm up the engine a trip on 20 km, then the transmission will have oil temperature at least +65°С. To establish the car on an equal surface. Let's to the engine of 2 minutes work idling. To tighten the hand brake to switch the lever of a choice of transfer to all provisions and to leave in situation P.
    To take out a measuring core and to wipe a pure rag.
    To insert a core back and to take out again. To check oil level. If necessary slowly to add oil by means of a funnel and a grid.

Level of oil should not be below the minimum marks, differently it can lead to transmission damages. If level of oil is above the maximum marks (F), it can lead to a box overheat that will cause a leakage. If level is too high, oil should be pumped out.

If oil of an automatic transmission has black color and a smell of burning, means, the transmission is faulty and should be checked in a workshop.