Mazda 323

since 1985 of release

Repair and car operation


Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
- Brake system
   Specifications of brake system
   Forward brake
   Removal and installation of forward brake shoes
   Check of thickness / lateral palpation of a brake disk
   Removal and installation of blocks of a back disk brake
   Removal and installation of a support of a brake
   Removal and installation of a brake disk
   Removal and installation of back brake blocks / brake drum
   Removal and installation of the wheel brake cylinder
   Repair of the wheel brake cylinder
   Brake liquid
   Pumping of brake system
   Replacement of brake pipelines and hoses
   Check of the brake amplifier
   Removal and installation of the switch of stoplights
   Hand brake
   Adjustment of the hand brake
   Anti-blocking system (ABS)
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits



Brake liquid

At the treatment of brake liquid it is necessary to consider the following:

    Brake liquid is poisonous. By no means it is impossible to suck away brake liquid through a hose a mouth. To pour brake liquid in the vessels intended only for it. Brake liquid corrodes and consequently should not get on varnish surfaces, if necessary at once to erase and wash away a large amount of water. Brake liquid is hygroscopic, it means, it absorbs moisture from air. Therefore brake liquid should be stored in the closed vessel. Brake liquid which was already used in the system, the second time should not be filled in. Also when pumping to add only fresh brake liquid. Specification of brake liquid: FMVSS 116 DOT 3 or SAE J1703. Brake liquid should not adjoin to greasing and mineral oil. Even insignificant traces of mineral oil do brake liquid unsuitable or conduct to an exit of brake system out of operation. It is necessary to replace brake liquid each 2 years, whenever possible after the termination of a winter season. It is necessary to hand over old brake liquid in special points, not to merge in the sewerage. Not to mix brake liquid with engine oil.