Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
- Brake system
Specifications of brake system
Forward brake
Removal and installation of forward brake shoes
Check of thickness / lateral palpation of a brake disk
Removal and installation of blocks of a back disk brake
Removal and installation of a support of a brake
Removal and installation of a brake disk
Removal and installation of back brake blocks / brake drum
Removal and installation of the wheel brake cylinder
Repair of the wheel brake cylinder
Brake liquid
Pumping of brake system
Replacement of brake pipelines and hoses
Check of the brake amplifier
Removal and installation of the switch of stoplights
Hand brake
Adjustment of the hand brake
Anti-blocking system (ABS)
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits
|
Removal and installation of the wheel brake cylinder Removal
|
|
To remove brake shoes.
To weaken a cap nut of the brake pipeline on the wheel cylinder from a reverse side. | Brake liquid will follow thus, to substitute specially intended vessel. To observe rules of the treatment of brake liquid, see. Section Pumping of brake system. |
|
|
To turn out 2 bolts of fastening-1-wheel cylinders on a reverse side of a board of a brake.
|
To remove the wheel brake cylinder.
To close a brake hose a suitable stopper, to avoid big loss of liquid and dirt penetration.
|
|
Installation
|
|
To establish the wheel cylinder on a board of a brake and to tighten 2 bolts with effort of 10 Nanometers.
To take out a plug and to tighten a cap nut of the brake pipeline with effort of 20 Nanometers.
To establish brake shoes.
To pump over brake system. Thus, as a rule, it is enough to pump over only that cylinder where the pipeline was opened. If brake pressure after pumping floats, it is necessary to pump over all system.
Several times strongly to squeeze out a brake pedal. It regulates back brakes.
|
|
|
|
