Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
- Brake system
   Specifications of brake system
   Forward brake
   Removal and installation of forward brake shoes
   Check of thickness / lateral palpation of a brake disk
   Removal and installation of blocks of a back disk brake
   Removal and installation of a support of a brake
   Removal and installation of a brake disk
   Removal and installation of back brake blocks / brake drum
   Removal and installation of the wheel brake cylinder
   Repair of the wheel brake cylinder
   Brake liquid
   Pumping of brake system
   Replacement of brake pipelines and hoses
   Check of the brake amplifier
   Removal and installation of the switch of stoplights
   Hand brake
   Adjustment of the hand brake
   Anti-blocking system (ABS)
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits



Виды сварочных рукавов

Adjustment of the hand brake

Brakes of back wheels are regulated automatically, according to wear of brake shoes. Adjustment of the hand brake is necessary only at replacement of the lever or a cable of the hand brake or if the hand brake does not hold despite sufficient thickness of blocks.

 PERFORMANCE ORDER

    To start the engine and several times to squeeze out a brake pedal, then the engine to muffle.
    To lift a back part of the car. To check the correct laying and faultless fastening of a cable of the hand brake. To release the lever of the hand brake. Slowly to pull the lever of the hand brake up and to count number of clicks. Demanded value:
      Cars to 9/89 g вып. and versatile person models: To tighten the lever of the hand brake with effort about 200 N (there correspond 20 kg) - a lever Course on cars with drum-type brakes should make from 7 to 11 clicks, on cars with disk brakes — from 9 to 15 clicks. Cars from 10/89 g вып., except "versatile person": To tighten the lever with effort about 100 N (there correspond 10 kg). The course of the lever should make from 5 to 7 clicks.
    If value does not correspond demanded, to adjust a hummock drive. The adjusting nut is on a cable, and it is possible to reach it, without removing the console.
    To turn an adjusting nut, the correct course of the lever will not be reached yet. The usual key best of all is suitable for rotation. The adjusting nut самоконтрящаяся, i.e. законтривать it is not required.
    After adjustment to lift a back part of the car and at the released hand brake to turn back wheels a hand. They should rotate easily, thus brakes should not rub, differently repeat adjustment.