Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
- Brake system
   Specifications of brake system
   Forward brake
   Removal and installation of forward brake shoes
   Check of thickness / lateral palpation of a brake disk
   Removal and installation of blocks of a back disk brake
   Removal and installation of a support of a brake
   Removal and installation of a brake disk
   Removal and installation of back brake blocks / brake drum
   Removal and installation of the wheel brake cylinder
   Repair of the wheel brake cylinder
   Brake liquid
   Pumping of brake system
   Replacement of brake pipelines and hoses
   Check of the brake amplifier
   Removal and installation of the switch of stoplights
   Hand brake
   Adjustment of the hand brake
   Anti-blocking system (ABS)
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits




Replacement of brake pipelines and hoses

In brake system as pipelines tubes which together with hoses of a high pressure provide connection of brakes with the main brake cylinder are applied.

Brake hoses represent flexible connections between motionless parts of the car.

Removal

 PERFORMANCE ORDER

    To lift the car. To unscrew and remove a brake hose on a support or the wheel brake cylinder.
    To remove a fastening bracket on an amortization rack by means of flat-nose pliers.
    To unscrew a brake hose from the coupling of the rigid pipeline. To stop up the pipeline to the main brake cylinder with a suitable stopper, or previously to pump out brake liquid from a compensatory tank by means of a suction.

Installation

 PERFORMANCE ORDER

    To establish brake hoses of only factory manufacturing. To screw a new brake hose on the rigid pipeline with effort of 20 Nanometers. This moment of an inhaling belongs also to other connections of rigid pipelines. To establish a new brake hose so that it when finding wheels on the average situation sagged not overwound. To fix a brake hose a bracket in fastening on an amortization rack. Disk brakes: To screw a brake hose on a support with 2 new laying with effort of 30 Nanometers, thus the pin on connection should enter into an opening on a support.
    After installation at the unloaded wheel (the car is lifted) to check, that the hose followed all movements of a wheel and did not rub anywhere.

Not to allow hit on brake hoses of oil or gasoline, not to varnish them and not to cover with mastic of protection of the bottom.

    To pump over brake system, see. Section Pumping of brake system. To lower the car.