Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
- Brake system
   Specifications of brake system
   Forward brake
   Removal and installation of forward brake shoes
   Check of thickness / lateral palpation of a brake disk
   Removal and installation of blocks of a back disk brake
   Removal and installation of a support of a brake
   Removal and installation of a brake disk
   Removal and installation of back brake blocks / brake drum
   Removal and installation of the wheel brake cylinder
   Repair of the wheel brake cylinder
   Brake liquid
   Pumping of brake system
   Replacement of brake pipelines and hoses
   Check of the brake amplifier
   Removal and installation of the switch of stoplights
   Hand brake
   Adjustment of the hand brake
   Anti-blocking system (ABS)
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits






Removal and installation of the switch of stoplights

Check of the switch of stoplights see. Head electric equipment System.

The switch of stoplights is over a brake pedal on the block of pedals.

Removal

A — the switch of stoplights
B — a lock-nut

C — a pusher bar
D — a lock-nut


 PERFORMANCE ORDER

  1. To switch off ignition.
  2. To disconnect the tip from the switch of stoplights.
  3. To weaken a lock-nut and to unscrew the switch.

Installation

 PERFORMANCE ORDER

  1. To measure pedal height to a floor. Demanded value see. Section Specifications of brake system.
  2. If the height of a pedal does not correspond to demanded value, to adjust height and люфт pedals in a workshop.
  3. To screw the switch of stoplights while it will not concern a pedal and then to tighten for a half of turn. To tighten a lock-nut.
  4. To connect the tip and to include ignition.
  5. To squeeze out a brake pedal, thus to ask the assistant to watch stoplights. Already by easy pressing a pedal they should join, differently respectively to adjust the switch.