Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
- Governing bodies and operation receptions
   Before landing in the car
   Running in
   Keys
   Locks of doors
   The uniform (central) locking device (if is available)
   Protection against pranks of children (if is available, only on back doors)
   Electric window regulator (if is available)
   Back rotary glasses (on 3-door models)
   Seats
   Adjustment of height of a steering wheel (if is available)
   Seat belts (if is available)
   Door back/trunk lid
   Fuelling
   Mirrors
   Luggage belts
   Trunk lid (if is available)
   Spare wheel
   Dashboard
   - Steering wheel and gear shifting
      Lock of ignition and steering column
      Engine start
      Management of RKPP and transfer case
      Car operation with an automatic transmission
      Recommendations for economic operation
      Tempostat (switch of a mode of maintenance of constant speed)
      Lighting and light alarm system
      Screen wiper and stekloomyvatel
      Control panel
      Other devices and equipment
      Heater and ventilation
      The conditioner (if is available)
      Lamps of salon, luggage carrier and lamp for reading (if is available)
      The movable hatch (if is available)
      Start by pushing or towage
      Impellent compartment
+ Electric circuits






Tempostat (switch of a mode of maintenance of constant speed)

With the help темпостата, since speed of 40 km/h, constant speed of movement of the car can be supported.

For inclusion press the CRUISE MAIN key dashboards.

For switching off once again press a key.

Installation of desirable speed of the car

 PERFORMANCE ORDER

  1. Disperse the car till desirable speed (at least 40 km/h).
  2. Quickly press the SET key on the end of the switch of lighting. Do not hold a key of the pressed.
  3. Release a gas pedal. The established speed will be supported by a constant.

Increase in speed of the car

 PERFORMANCE ORDER

  1. Press the SET key and hold it pressed. The car will be evenly accelerated.
  1. At achievement of desirable speed release a key.

Decrease in speed of the car

 PERFORMANCE ORDER

  1. Establish the COAST-RESUME button on the cleaner and washer switch in a position of "COAST" and hold in this situation.
  1. Speed will slowly decrease. When desirable speed will be reached, release the button. After that again established speed will be supported by a constant.

Switching off

 PERFORMANCE ORDER

  1. Press the CRUISE MAIN key to switch off a mode of maintenance of constant speed.
  2. Slightly squeeze out a brake or coupling pedal.
  3. Establish the switching lever (on an automatic transmission) in the situation "N".
  4. The switch of a mode of constant speed will automatically be switched off, when speed of the car will be lower established on 15 km/h.

Repeated inclusion at speed is higher than 40 km/h

 PERFORMANCE ORDER

  1. Again to include the last established speed, turn the COAST-RESUME button to the right in a position of "RESUME" release the button. The car will automatically be dispersed till last established speed. At speed below 40 km/h the switch of a mode of constant speed is switched off, while speed will not be again more than 40 km/h. Then again turn the COAST-RESUME button to the right and release it.
  1. The car will automatically be accelerated till the speed established before it, and this speed will be supported by a constant.

  • For acceleration when overtaking with the included mode of maintenance of constant speed squeeze out a gas pedal as usual. When you again release a gas pedal, the speed set earlier will again be established.
  • At strong lifting or descent in a mode of maintenance of constant speed speed of the car can deviate a little.

Do not include a mode of maintenance of constant speed in a dense transport stream which has no constant speed, and on the twisting, ice-covered, crude or slippery road.