Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
- Power supply system, carburetor, system of injection of fuel
   Purity rules at work with a power supply system
   Removal and sensor installation/check in a fuel tank
   Removal and installation of a fuel tank
   Removal and installation of the fuel pump
   Removal and installation/check of the fuel pump
   Removal and installation of the air filter
   - Carburetor
      Carburetor adjustment
      Malfunctions in system of supply of fuel
      The carburetor with a falling stream and consecutive turning on of chambers
      Check and contents adjustment WITH
      Check/removal and installation of the valve of interruption of supply of fuel
      Check/removal and installation of automatic equipment of cold start
      Removal and carburetor installation
   + System of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits




Carburetor

Each carburetor is checked and regulated at plant. In this adjustment of anything it is impossible to change. High fuel consumption and insufficient engine capacity almost always have other reasons among which the important role is played by a manner and traffic conditions. As a rule, it is enough to be limited to careful adjustment of idling and structure WITH. The correct adjustment of idling is much more important, than it is accepted to think, as it influences operation of the engine to average turns.

Carburetor screws by means of which it is possible to change composition of the fulfilled gases, on the basis of the law should be protected by seals. If the carburetor has seals, it is possible to remove them with nippers or a screw-driver. It is expedient to screw in a seal the suitable screw саморез and to take out it together with a seal. Thus they collapse. After adjustment screws should be protected by new seals.

At works on the carburetor and system of supply of fuel certain rules of purity should be observed, see. Head the Power supply system, the carburetor, system of injection of fuel, the Section of the Rule of purity at work with a power supply system.