Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
- Power supply system, carburetor, system of injection of fuel
   Purity rules at work with a power supply system
   Removal and sensor installation/check in a fuel tank
   Removal and installation of a fuel tank
   Removal and installation of the fuel pump
   Removal and installation/check of the fuel pump
   Removal and installation of the air filter
   - Carburetor
      Carburetor adjustment
      Malfunctions in system of supply of fuel
      The carburetor with a falling stream and consecutive turning on of chambers
      Check and contents adjustment WITH
      Check/removal and installation of the valve of interruption of supply of fuel
      Check/removal and installation of automatic equipment of cold start
      Removal and carburetor installation
   + System of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits






Check/removal and installation of the valve of interruption of supply of fuel

If the engine will continue to work after ignition switching off, it is necessary to check the valve of interruption of supply of fuel.

Check

 PERFORMANCE ORDER

  1. To leave the engine to idle.
  1. To disconnect the combined tip of the valve of interruption of supply of fuel and the electromagnetic ventilating valve.
  1. If the engine stops, the valve of interruption of supply of fuel is serviceable, if the engine continues to work, it is necessary to replace the valve.

Removal

 PERFORMANCE ORDER

  1. To remove the air filter.
  2. To disconnect the combined tip of the valve of interruption of supply of fuel and the electromagnetic ventilating valve.
  1. To unscrew the valve of interruption of supply of fuel - an arrow-.
  1. To take out the tip of the locking valve from the case of the combined tip.

Installation

 PERFORMANCE ORDER

  1. To establish the valve of interruption of supply of fuel with new laying and to screw in it.
  2. To insert the tip into the case of the combined tip.
  3. To connect the combined tip.
  4. To establish the air filter.