Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
- Power supply system, carburetor, system of injection of fuel
Purity rules at work with a power supply system
Removal and sensor installation/check in a fuel tank
Removal and installation of a fuel tank
Removal and installation of the fuel pump
Removal and installation/check of the fuel pump
Removal and installation of the air filter
- Carburetor
Carburetor adjustment
Malfunctions in system of supply of fuel
The carburetor with a falling stream and consecutive turning on of chambers
Check and contents adjustment WITH
Check/removal and installation of the valve of interruption of supply of fuel
Check/removal and installation of automatic equipment of cold start
Removal and carburetor installation
+ System of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits
|
Removal and carburetor installation
|
|
At removal of the carburetor a fuel quantity can act. Pairs of fuel are poisonous and inflammable therefore to pay special attention to good ventilation of a workplace. To avoid fuel hit on skin, to work in toplivostoyky mittens. Not to work near open fire. |
Removal
|
|
To disconnect a weight cable from the battery.
To remove the air filter-2-, see. Head Power supply system, carburetor, system of injection of fuel, Section Removal and installation of the air filter.
If is available, to unscrew the holder from the air filter.
To remove a gas-3-drive. Previously to mark the adjusting provision of a cover of a cable on a countersupport. | The cable of gas should not be bent, differently it will burst in use. The bent cable in any case to replace. |
To disconnect топливопровод-4-and to stop up it, previously having weakened and having shifted back a collar. As a cap the pure bolt of the corresponding diameter can be used.
To disconnect vacuum hoses-5-on the case of the carburetor and to mark them with a sticky tape.
|
|
To disconnect electric connections-6-and-7-and to mark them with a sticky tape.
|
To unscrew a nut of fastening of the carburetor and to raise the carburetor-8-.
To remove the heating tip.
To remove a heater-9-and laying.
To cover an inlet pipe with a pure rag that dirt there could not get.
|
|
Installation
|
|
To clean a rag, to establish the carburetor with new laying on a flange and to screw it.
To connect vacuum hoses according to marking to the carburetor case.
To connect a fuel hose and to fix a collar.
To establish a drive of gas and a starting zaslonka. To clamp a cable cover according to the put marking.
To attach a returnable spring of the lever of a butterfly valve.
If is available, to screw the holder of the air filter.
To establish the air filter, see. Head Power supply system, carburetor, system of injection of fuel, Section Removal and installation of the air filter.
To connect a cable of weight of the battery.
If are available, to establish time on hours and to set a protective code of a radio receiver.
To check idling and the contents WITH, if necessary to adjust.
|
|
|
|