Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
- Power supply system, carburetor, system of injection of fuel
   Purity rules at work with a power supply system
   Removal and sensor installation/check in a fuel tank
   Removal and installation of a fuel tank
   Removal and installation of the fuel pump
   Removal and installation/check of the fuel pump
   Removal and installation of the air filter
   + Carburettor
   - System of injection of fuel
      System of injection of fuel
      Memory of malfunctions
      Security measures at work with injection system
      Idling check
      Verification of the contents WITH
      Check/adjustment of the sensor of a butterfly valve
      Removal and installation/check of the sensor of temperature of cooling liquid
      Check of gates of injection (injectors)
      Removal and installation of gates of injection
      Check of the fuel pump
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits




Removal and installation/check of the sensor of temperature of cooling liquid

The sensor of temperature of cooling liquid should be checked, if the cold engine is badly started or works with interruptions. The sensor of temperature of cooling liquid is in dependence years of release and the engine or on a reverse side of the engine, or in an inlet collector.

Removal

 PERFORMANCE ORDER

    To disconnect the tip of the sensor of temperature of cooling liquid.
    To unscrew the temperature sensor. To substitute a pure vessel and to collect following cooling liquid.

Check

 PERFORMANCE ORDER

    To suspend the temperature sensor in capacity with water and slowly to heat up water.
    To measure resistance of the sensor of temperature by an ohmmeter. For this purpose to connect one plug of an ohmmeter to the case, other plug of an ohmmeter to the sensor plug.
Temperature Resistance in Ohm
- 20°С 14,2 — 17,8
20°С 2,2 — 2,7
40°С 1,0 — 1,3
60°С 0,50 — 0,65
80°С 0,29 — 0,35

Installation

 PERFORMANCE ORDER

    To establish the temperature sensor with new laying and to screw with effort of 25 Nanometers. To fill in cooling liquid. To warm up the engine and to leave to idle, the radiator fan will not turn on yet. Once again to check level of cooling liquid.