Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
- Wheels and tires, body, car coloring, care of the car
   The sizes of disks and tires/pressure in tires
   Designations of disks
   Designations of tires
   Replacement of wheels
   Rules of care of tires
   Balancing of wheels
   Antisliding chains
   Spare wheel
   Wear of tires
   Body
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal and front grille installation
   Removal and installation of lateral moldings
   Removal and installation of a forward wing
   Removal and cowl installation/adjustment
   Removal and installation/adjustment of a door of a back
   Removal and door installation/adjustment
   Upholstery door door/window regulator/glass
   Removal and installation of an upholstery of a door
   Removal and installation of a glass/window regulator of a forward door
   Lock/handle/cylinder of the lock of a door
   Lock of a door of a back / internal drive
   External mirror
   Removal and installation of glass of a mirror
   Panel of devices / average console
   Forward seats
   Removal and installation of a back seat
   Back seat
   Car coloring
   Elimination of damages from stones
   Rikhtovka body/repair of rusty openings
   Preparation for painting
   Coloring
   Wash of the car
   Care of a varnish covering
   Protection of the bottom and preservation of cavities
   Care of an upholstery
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits




Removal and installation of lateral moldings

Removal

 PERFORMANCE ORDER

    Lateral moldings depending on model can be pasted, established on latches or both that, and another. A short element on a forward wing on cars with 9/85 on 8/89 g вып. fastens on the 2nd rivets from a wheel arch. From 10/89 g вып. this molding is pasted, on models the hatchback is screwed together with the lateral index of turn.
    A few to delay a molding and to separate glue a sharp knife.

Thus not to scratch the varnished surface.


    Glutinous connection between a molding and a body can be separated a thin nylon cord (diameter of 0,8 mm). For simplification of work to adhere by both ends of a cord wooden whetstones. When the latch comes across, to raise a molding in this place. That glue departed better, to heat up a molding the hair dryer to +40°С.

Installation

 PERFORMANCE ORDER

    To clear glue places on a body gasoline. If the new molding is established, to remove from noted places a protective film.
    If the old molding is again established, to wash away the remains gluing gasoline and to put a bilateral sticky tape.

(9/85-9/89 вып.).

 PERFORMANCE ORDER

    To mark a sticky tape the adjusting provision of a molding on a body.
    To heat up a molding and a body approximately to +40 ° — + 80°С. To latch each button in palm blow.

From 10/89 g вып.

 PERFORMANCE ORDER

    To ground a molding in the designated places.
    To paste on the shaded places a bilateral sticky tape. On an internal part to put poliuretanovy glue.