Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
- Wheels and tires, body, car coloring, care of the car
The sizes of disks and tires/pressure in tires
Designations of disks
Designations of tires
Replacement of wheels
Rules of care of tires
Balancing of wheels
Antisliding chains
Spare wheel
Wear of tires
Body
Removal and installation of a front bumper
Removal and installation of a rear bumper
Removal and front grille installation
Removal and installation of lateral moldings
Removal and installation of a forward wing
Removal and cowl installation/adjustment
Removal and installation/adjustment of a door of a back
Removal and door installation/adjustment
Upholstery door door/window regulator/glass
Removal and installation of an upholstery of a door
Removal and installation of a glass/window regulator of a forward door
Lock/handle/cylinder of the lock of a door
Lock of a door of a back / internal drive
External mirror
Removal and installation of glass of a mirror
Panel of devices / average console
Forward seats
Removal and installation of a back seat
Back seat
Car coloring
Elimination of damages from stones
Rikhtovka body/repair of rusty openings
Preparation for painting
Coloring
Wash of the car
Care of a varnish covering
Protection of the bottom and preservation of cavities
Care of an upholstery
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits
|
Removal and installation of an upholstery of a door
|
|
Removal for a forward door is described. Removal should be made for a back door as appropriate. |
Removal
|
|
To disconnect a weight cable from the battery.
At manual adjustment of a mirror to unscrew the driving lever, previously having removed a slip a small screw-driver, see. Head of the Wheel and tire, body, car coloring, care of the car.
To remove an overlay of a triangle of a door.
|
|
C3/91 вып.: To take out an overlay of the button of a lock of a door a small screw-driver and to remove together with the anti-static button. Not to damage an upholstery, to enclose under a screw-driver a piece of a cardboard.
|
|
|
The anti-static button is connected to weight a metal element. Thanks to a contact of this button before an exit it is possible to avoid electric blow a static charge. |
|
|
To remove the window regulator handle. For this purpose to enter a screw-driver or a piece of a matter between a remote washer and the handle and to press a lock bracket. At the same time to remove the handle from a shaft. If the handle not to reach, it is possible to remove a lock bracket with the bent wire.
|
To unscrew the internal handle of a door and to disconnect from driving draft.
To unscrew an upholstery of a door and to remove it. To disconnect the tip on the switch of an electric regulator of a mirror.
To wring out a door upholstery from a frame a wide polymeric or wooden wedge. Thus buttons of fastening are released from captures. To remove an upholstery.
If it is required, to remove a sealing film from a door, thus whenever possible not to tear it.
|
|
Installation
|
|
|
|
Carefully to paste a sealing film on a frame from below up. The film serves for salon isolation from drafts, noise and water hit. At insufficiently good glutinous layer to use a bilateral sticky tape. The broken-off film to stick with a sticky tape. At considerable gaps to replace a film.
|
To check buttons of fastening of an upholstery of a door. The damaged and pognuty buttons to replace.
If is available, to connect a cable of an external mirror.
To establish a door upholstery at first from above, then to insert from below and in the field of buttons of fastening to fix in blows of the back party of a palm.
To screw a door upholstery.
To insert and screw the internal handle of a door.
To put on the window regulator handle with the inserted lock bracket a shaft so that at the closed window the handle settled down the same as on the antiput door.
At manual adjustment of a mirror to screw the driving lever, then to establish an overlay of bolts, see. Head of the Wheel and tire, body, car coloring, care of the car.
To establish an overlay of a triangle of a door.
C3/91 вып.: To press and latch in an upholstery an overlay of the locking button of a door with the anti-static button.
To connect a weight cable to the battery.
If are available, to establish time on hours and to set a protective code of a radio receiver.
|
|
|
|
