Mazda 323
+ Introduction + Petrol engines + System of greasing of the engine + System of cooling of the engine + ignition System + Power supply system, carburetor, system of injection of fuel + Diesel engine + System of production of the fulfilled gases + Coupling + Manual transmission + Automatic transmission + Suspension bracket and steering system + Brake system - Wheels and tires, body, car coloring, care of the car The sizes of disks and tires/pressure in tires Designations of disks Designations of tires Replacement of wheels Rules of care of tires Balancing of wheels Antisliding chains Spare wheel Wear of tires Body Removal and installation of a front bumper Removal and installation of a rear bumper Removal and front grille installation Removal and installation of lateral moldings Removal and installation of a forward wing Removal and cowl installation/adjustment Removal and installation/adjustment of a door of a back Removal and door installation/adjustment Upholstery door door/window regulator/glass Removal and installation of an upholstery of a door Removal and installation of a glass/window regulator of a forward door Lock/handle/cylinder of the lock of a door Lock of a door of a back / internal drive External mirror Removal and installation of glass of a mirror Panel of devices / average console Forward seats Removal and installation of a back seat Back seat Car coloring Elimination of damages from stones Rikhtovka body/repair of rusty openings Preparation for painting Coloring Wash of the car Care of a varnish covering Protection of the bottom and preservation of cavities Care of an upholstery + electric equipment System + Heater, lighting system, devices + Governing bodies and operation receptions + Electric circuits
|
Spare wheel When using a compact spare wheel it is necessary to carry out the following rules:
The spare wheel can be mounted in front and behind.
The spare wheel is intended only for compelled short-term use. In a case as soon as possible it is necessary for installation of a spare wheel to replace it with a normal wheel.
After installation of a spare wheel as soon as possible it is necessary to check pressure, pressure should make 4,2Бар. With the established spare wheel it is impossible to move quicker 80 km/h. To avoid dispersal with full gas, sharp braking and abrupt turns.
The spare wheel is less than usual. Therefore at the corresponding axis coupling with the road decreases. For prevention of damage of deeply planted elements of the car it is not necessary to move through big obstacles and deepenings. With the established spare wheel it is impossible to use an automatic sink.
The spare wheel is developed specially for this type of the car. Therefore it should not be used on cars of other type. Also on on this car spare wheels of other type should not be used.
Application on a spare wheel of chains of antisliding is inadmissible for technical reasons. If it is necessary to use antisliding chains, the spare wheel is necessary to establish back, and a normal back wheel on a forward axis. It is thus recommended to impose chains already before installation.
On a disk of a spare wheel summer or winter tires should not be mounted.
Never to establish two spare wheels at the same time.
|
|