Mazda 323
+ Introduction + Petrol engines + System of greasing of the engine + System of cooling of the engine + ignition System + Power supply system, carburetor, system of injection of fuel + Diesel engine + System of production of the fulfilled gases + Coupling + Manual transmission + Automatic transmission + Suspension bracket and steering system + Brake system - Wheels and tires, body, car coloring, care of the car The sizes of disks and tires/pressure in tires Designations of disks Designations of tires Replacement of wheels Rules of care of tires Balancing of wheels Antisliding chains Spare wheel Wear of tires Body Removal and installation of a front bumper Removal and installation of a rear bumper Removal and front grille installation Removal and installation of lateral moldings Removal and installation of a forward wing Removal and cowl installation/adjustment Removal and installation/adjustment of a door of a back Removal and door installation/adjustment Upholstery door door/window regulator/glass Removal and installation of an upholstery of a door Removal and installation of a glass/window regulator of a forward door Lock/handle/cylinder of the lock of a door Lock of a door of a back / internal drive External mirror Removal and installation of glass of a mirror Panel of devices / average console Forward seats Removal and installation of a back seat Back seat Car coloring Elimination of damages from stones Rikhtovka body/repair of rusty openings Preparation for painting Coloring Wash of the car Care of a varnish covering Protection of the bottom and preservation of cavities Care of an upholstery + electric equipment System + Heater, lighting system, devices + Governing bodies and operation receptions + Electric circuits
|
Wash of the car
|
In many areas the car wash on the open areas is forbidden. |
|
The dirty car to wash whenever possible quicker.
Traces from dead insects to delete to a wash of the car.
To use a large amount of water.
To use a soft sponge or very soft brush.
Not to direct a strong stream of water on a varnish covering.
To wash away the softened dirt from top to down.
Often to rinse a sponge.
For drying to use soft skin.
To use only good, firm detergent. Carefully to rinse the car with pure water, to remove the detergent remains.
For protection of a varnish covering in water it is possible to add washing preservative.
At frequent use of detergent preservation should be made more often.
Never to wash and not to dry the car under the open sun. Otherwise on a varnish covering emergence of spots is inevitable.
Flanges and cracks of doors and a cowl are most of all subject to salt influence. Therefore these places at each sink, and also after an automatic sink, should be cleared carefully by a sponge and be dried or wiped by skin.
|
After a sink brake influence a little decreases. Therefore it is necessary to dry brake disks. From insects, oil and bitumen not always it is possible to remove traces with one sink. Similar pollution should be removed whenever possible quicker as differently they can cause damages of a varnish covering. Then on these places preservation should be made. |
|
|
|
|