Mazda 323

since 1985 of release

Repair and car operation

Replacement of wheels

At replacement of wheels it is not recommended to change the direction of rotation of the tire as grinding in is reached by very considerable wear of the tire.

At obvious wear of forward tires it is recommended to trade places lobbies and back wheels. Thus, all tires have identical service life.

At an inhaling of nuts of a wheel the dinamometrichesky key should be applied always. It provides a uniform inhaling of bolts.

Not to replace the tire on one. At least, to replace at once both tires on one axis. Thus tires with better profile always to establish forward.

At replacement or dismantle of tubeless tires it is recommended to replace the rubber gate.

PERFORMANCE ORDER

To remove rust traces on surfaces of a prileganiye of a disk with a wire brush. For protection of disks against a rzhavleniye at each removal of wheels it is necessary to cover naves in front and behind with greasing for kacheniye bearings. To remove a wheel cap the flat end of a key for wheel nuts.

Before removal to mark the provision of a wheel concerning a nave with chalk that it was possible to establish a wheel in former situation.

Legkometallichesky disks are protected from corrosion by a transparent varnish. At replacement of wheels to watch, that the protective varnish was not damaged, otherwise to tint a colourless varnish.

To legkometallichesky disks to apply only the nuts provided for them.

If on the car legkometallichesky disks while the spare wheel has a steel disk are established, it is recommended to have in the car the corresponding nuts for a steel disk.

To clear the polluted nuts and a carving. To tighten wheel nuts cross-wise for some passes.

Because of a unilateral inhaling of nuts the wheel and/or a nave can warp.

The moment of an inhaling of all nuts of a wheel makes 100 Nanometers,

home