Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
- Wheels and tires, body, car coloring, care of the car
The sizes of disks and tires/pressure in tires
Designations of disks
Designations of tires
Replacement of wheels
Rules of care of tires
Balancing of wheels
Antisliding chains
Spare wheel
Wear of tires
Body
Removal and installation of a front bumper
Removal and installation of a rear bumper
Removal and front grille installation
Removal and installation of lateral moldings
Removal and installation of a forward wing
Removal and cowl installation/adjustment
Removal and installation/adjustment of a door of a back
Removal and door installation/adjustment
Upholstery door door/window regulator/glass
Removal and installation of an upholstery of a door
Removal and installation of a glass/window regulator of a forward door
Lock/handle/cylinder of the lock of a door
Lock of a door of a back / internal drive
External mirror
Removal and installation of glass of a mirror
Panel of devices / average console
Forward seats
Removal and installation of a back seat
Back seat
Car coloring
Elimination of damages from stones
Rikhtovka body/repair of rusty openings
Preparation for painting
Coloring
Wash of the car
Care of a varnish covering
Protection of the bottom and preservation of cavities
Care of an upholstery
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits
|
Removal and installation/adjustment of a door of a back
MAZDA 323 from 10/89 g вып.
To remove details in sequence. Previously to disconnect a weight cable from the battery.
| Data from memory of malfunctions of the engine or protective code of a radio receiver are thus erased. Before shutdown of the battery it is necessary to read instructions in the Section Removal and battery installation. After installation of the battery to connect a cable of weight and if are available, to establish time on hours and to set a protective code of a radio receiver. |
Removal
|
|
To disconnect a hose of a nozzle of a stekloomyvatel.
To disconnect the tip. Previously to remove an upholstery of a back rack of a body and seat belt fastening.
To mark the adjusting provision of a door of a back, for this purpose to lead round bolts on the hinge a felt-tip pen. | If it is required to remove hinges, previously it is necessary to remove an internal surface of a ceiling to reach a bolt. |
To prop up a back door.
To unscrew from a body a gas-filled emphasis.
|
|
At replacement of a gas-filled emphasis before utilization it is necessary to remove gas (it is carried out in a workshop) from an old emphasis. Gas colourless, flavourless and nonpoisonous. |
To turn out bolts on the hinge and to remove a back door. The help of the assistant is for this purpose necessary. Before weakening of bolts of hinges to put between a door and a body a fabric for protection of varnish surfaces.
|
|
Installation
|
|
To establish a back door, to screw bolts, to level a door and to tighten bolts with effort of 10 Nanometers.
To screw a gas-filled emphasis. | At completely stretched emphasis not to turn a rod of the piston and the cylinder from each other. |
To put on a hose of a nozzle of a stekloomyvatel.
To connect the tip of the motor of a screen wiper and a heater of back glass. To establish an upholstery of a back rack of a body and seat belt fastening.
|
|
Adjustment of a door of a back
|
|
To weaken bolts on the hinge and to tighten so that a door still moved. It is represented by MAZDA 323 from 10/89 g вып. To adjust a door according to the sizes (in mm). On cars with 9/85 on 9/89 g вып. to level a door so that it settled down in parallel and at identical distance from other elements.
To tighten bolts or nuts of hinges with effort of 10 Nanometers.
To close a door of a back and to check, that the door was closed easily and had no too big gaps. If necessary to adjust a locking plate.
To weaken both bolts of fastening of a locking plate that it still moved.
|
|
To close a door of a back and to level a plate with the lock on a back door. Then to tighten bolts with effort of 20 Nanometers.
|
|
|
|
|