Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
- Electric equipment system
   Search of malfunctions of electric system
   Switch check on a current transmission
   Relay check
   Check of the motor of a screen wiper
   Verification of indexes of turn
   Check of stoplights
   Check of a heater of back glass
   Separation and connection of cable tips
   Arrangement of safety locks
   Replacement of safety locks
   Removal and battery installation
   Battery check
   The battery is discharged in itself
   Battery charging
   Battery storage
   Generator
   Security measures for the generator of an alternating current
   Check of tension of the generator
   Removal and generator installation
   Generator components
   Dismantling generator/replacement of coal brushes
   Removal and starter installation
   Check/replacement of the traction relay of a starter
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits



трава живучка

Security measures for the generator of an alternating current

    At works on electric system in an impellent compartment it is obligatory to disconnect a cable of weight of the battery.

Data from memory of an electronic monitor of system of injection and protective code of a radio receiver are thus erased. Therefore before shutdown it is obligatory to read instructions in the Section Removal and battery installation.

    Not to mix cables of a regulator of tension and the generator. To mark cables before shutdown by a sticky tape. Not to disconnect the battery or a tension regulator on the working engine. Not to remove the generator at the connected battery. At electric welding the battery is obligatory for disconnecting.