Mazda 323

since 1985 of release

Repair and car operation


Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
- Electric equipment system
   Search of malfunctions of electric system
   Switch check on a current transmission
   Relay check
   Check of the motor of a screen wiper
   Verification of indexes of turn
   Check of stoplights
   Check of a heater of back glass
   Separation and connection of cable tips
   Arrangement of safety locks
   Replacement of safety locks
   Removal and battery installation
   Battery check
   The battery is discharged in itself
   Battery charging
   Battery storage
   Generator
   Security measures for the generator of an alternating current
   Check of tension of the generator
   Removal and generator installation
   Generator components
   Dismantling generator/replacement of coal brushes
   Removal and starter installation
   Check/replacement of the traction relay of a starter
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits



Verification of indexes of turn

Steps for indexes of turn and the alarm system are developed by one relay, the so-called breaker of signals of turn.

If a blinking rhythm on one party quicker than on another, from the "fast" party the lamp is faulty or there is a wire break.

At all other malfunctions more often the reason is the relay. For check of the relay to remove.

 From 10/89 g вып.

 PERFORMANCE ORDER

    To disconnect the relay and to check separate contacts on current course. Thus to establish on an ohmmeter a measurement limit килоомы (kiloohm). Between the following contacts the current should proceed or to be resistance: a-e; a-f; c-a; c-d; c-e; c-f; c-g; c-h; h-a; h-c; h-d; h-e; h-f; h-g.
    Between other contacts the current should not proceed, or resistance should be equal to infinity.

With 9/85 on 9/89 g вып.

 PERFORMANCE ORDER

    To connect through auxiliary cables battery plus to the plug B, mass of the battery to E.Zatem's plug between plugs L and E or E and weight to connect in parallel 2 lamps of indexes of turn (21 W). Lamps should blink in a normal rhythm, differently replace the relay.
    If the new relay is not present, carefully to insert a thin wire into the relay tip between plugs B and L

Sensitive contacts of the relay should not be thus damaged. Before installation the ends of a wire to bend, that there were no keen edges. To establish the faulty relay into place. Connection tips so long that the relay will be inserted despite a crossing point.

    To include ignition. If now to turn on the lever of signals of the turn, the corresponding lamp will light up, without blinking. Inclusion and switching off of the lever it is possible to set a rhythm. However: Whenever possible to establish the new relay quicker. If indexes of turn do not burn despite a crossing point of contacts, malfunction consists in the switch or electric wires.