Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
- Electric equipment system
   Search of malfunctions of electric system
   Switch check on a current transmission
   Relay check
   Check of the motor of a screen wiper
   Verification of indexes of turn
   Check of stoplights
   Check of a heater of back glass
   Separation and connection of cable tips
   Arrangement of safety locks
   Replacement of safety locks
   Removal and battery installation
   Battery check
   The battery is discharged in itself
   Battery charging
   Battery storage
   Generator
   Security measures for the generator of an alternating current
   Check of tension of the generator
   Removal and generator installation
   Generator components
   Dismantling generator/replacement of coal brushes
   Removal and starter installation
   Check/replacement of the traction relay of a starter
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits






Check of stoplights

 PERFORMANCE ORDER

  1. If stoplights do not burn, at first it is necessary to check a safety lock in a box of safety locks.
  2. If the safety lock is serviceable, to check lamps of stoplights, if necessary to replace.
  1. If lamps are serviceable, to check the switch of stoplights. The switch of stoplights is over a brake pedal on the block of pedals. By pressing of a pedal of a brake from the switch the pin is put forward. Contact of the switch becomes isolated, and stoplights light up.
  1. To check the switch of stoplights. For this purpose to disconnect from the switch the tip.
  2. To connect to switch contacts an ohmmeter. Resistance should be equal to infinity.
  3. To press a brake pedal. The ohmmeter should show now resistance of 0 Ohm. Otherwise to replace the switch.