Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and steering system
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
- Electric equipment system
   Search of malfunctions of electric system
   Switch check on a current transmission
   Relay check
   Check of the motor of a screen wiper
   Verification of indexes of turn
   Check of stoplights
   Check of a heater of back glass
   Separation and connection of cable tips
   Arrangement of safety locks
   Replacement of safety locks
   Removal and battery installation
   Battery check
   The battery is discharged in itself
   Battery charging
   Battery storage
   Generator
   Security measures for the generator of an alternating current
   Check of tension of the generator
   Removal and generator installation
   Generator components
   Dismantling generator/replacement of coal brushes
   Removal and starter installation
   Check/replacement of the traction relay of a starter
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits



остров саона в доминикане

Check of tension of the generator

 PERFORMANCE ORDER

    To connect the voltmeter between plusovy and minus battery poles. To start the engine. At start tension should not fall below 8 In (at external temperature +20°С). To increase number of turns to 2000 rpm. Tension should make 14,1 - 14,7 V.Eto are specified that the generator and a regulator work. Tension of the generator should be higher than tension of the battery that the battery was recharged at movement. To check stability of adjustment. For this purpose to include a driving beam and to repeat measurement at 2000 rpm. The measured tension should not be more than on 0,4 In above earlier measured value. If the measured values lie out of admissible limits, to check the generator in a workshop.