After easing cross-section/longitudinal levers rubber support can be tightened only if the car costs on wheels. Then it is necessary to measure corners of installation of wheels in a workshop.
1 — a stabilizer nut To screw so that a carving acted approximately on 18 mm. 2 — a sleeve, the plug, a remote element 3 — a bolt 4 — a cap 5 — a nut 6 — a washer 7 — a bolt
8 — a lock washer 9 — the forward cross-section lever 10 — the back cross-section lever The length changes for convergence adjustment, by means of the eccentric plug (to 9/89 g вып.) or a carving bar (since 10/89 g вып.). 11 — a bolt, a washer 12 — the longitudinal lever