Mazda 323
+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
- Suspension bracket and steering system
Forward suspension bracket — the general information
Removal and installation of an amortization rack
Dismantling amortization rack/removal and shock-absorber installation / screw spring
Shock-absorber check
Removal and installation cross-section lever/replacement of a rubber support
Check/replacement of a support of the cross-section lever / rotary fist
Removal and installation of a power shaft
Removal and installation of an intermediate shaft
Check/dismantling driving shaft/replacement of cuffs
Bearing of a forward nave
Back suspension bracket
Removal and installation of a back amortization rack
Dismantling back amortization rack/removal and shock-absorber installation / screw spring
Cross-section levers / longitudinal lever/stabilizer
Check of the bearing of a nave
Removal and installation of the bearing of a nave
Adjustment люфта nave bearing
Removal and nave installation
Steering
Removal and installation of a steering wheel
Removal and installation of a tip of steering draft
Removal and installation of a rubber cuff of a steering drive
Servoupravleniye pump
Corners of installation of wheels
Values for MAZDA 323 check
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits
|
Removal and installation of a tip of steering draft Removal
|
|
To weaken nuts of a wheel of the car standing on the earth.
To change the provision of a disk of a wheel concerning a nave that it was possible to establish an otbalansirovanny wheel in former situation.
To lift a forward part of the car.
To remove a wheel.
|
|
To unscrew a tip of steering draft - And - from the lever of a rotary fist - F-, for this purpose to take out шплинт - Е-and to unscrew a lock-nut - D-, - In - a lock-nut, - With - steering draft.
|
|
|
Выпрессовать a tip of steering draft - And - a standard stripper - With-. - In - the lever of a rotary fist.
|
To weaken a lock-nut and to unscrew a tip from steering draft. | To mark number of turns, to screw the hinge at installation in the same situation. |
|
|
Installation
|
|
To screw a tip of steering draft on the written-down number of turns, a lock-nut not to tighten yet.
To insert the hinge into the lever of a rotary fist.
To tighten a lock-nut with effort of 50 Nanometers and to fix new the shplinty. If шплинт it is not inserted into an opening, a nut not to weaken, and to tighten further while шплинт will not rise into place.
To screw a wheel, considering a label on a nave. To lower the car and to tighten wheel nuts cross-wise with effort of 100 Nanometers.
A few to rock the car that suspension bracket elements sat down.
To check convergence adjustment (it is carried out in a workshop) and to tighten a lock-nut on a tip of steering draft with effort of 40 Nanometers.
|
|
|
|
