Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
- Suspension bracket and steering system
   Forward suspension bracket — the general information
   Removal and installation of an amortization rack
   Dismantling amortization rack/removal and shock-absorber installation / screw spring
   Shock-absorber check
   Removal and installation cross-section lever/replacement of a rubber support
   Check/replacement of a support of the cross-section lever / rotary fist
   Removal and installation of a power shaft
   Removal and installation of an intermediate shaft
   Check/dismantling driving shaft/replacement of cuffs
   Bearing of a forward nave
   Back suspension bracket
   Removal and installation of a back amortization rack
   Dismantling back amortization rack/removal and shock-absorber installation / screw spring
   Cross-section levers / longitudinal lever/stabilizer
   Check of the bearing of a nave
   Removal and installation of the bearing of a nave
   Adjustment люфта nave bearing
   Removal and nave installation
   Steering
   Removal and installation of a steering wheel
   Removal and installation of a tip of steering draft
   Removal and installation of a rubber cuff of a steering drive
   Servoupravleniye pump
   Corners of installation of wheels
   Values for MAZDA 323 check
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits



BYD e6 - про автомобиль BYD e6

Check of the bearing of a nave

Sign of malfunction of the bearing of a nave is unusual noise at the movement, beginning only on a certain (high) speed.

Check

 PERFORMANCE ORDER

    To release the hand brake. To lift a back part of the car.
    To check люфт the bearing of a nave delaying and pressing a wheel on the forward and back parties. Should not be notable люфта.
    To turn a wheel a hand. The bearing should rotate easily and evenly, should not be thus audible noise from rotation.
    In workshops axial люфт it is measured by means of the strelochny indicator at the removed back wheel on a brake drum. The bearing should not have люфт more than 0,05 mm, differently it is necessary to adjust or replace it.