Mazda 323

since 1985 of release

Repair and car operation



Mazda 323

+ Introduction
+ Petrol engines
+ System of greasing of the engine
+ System of cooling of the engine
+ ignition System
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
- Suspension bracket and steering system
   Forward suspension bracket — the general information
   Removal and installation of an amortization rack
   Dismantling amortization rack/removal and shock-absorber installation / screw spring
   Shock-absorber check
   Removal and installation cross-section lever/replacement of a rubber support
   Check/replacement of a support of the cross-section lever / rotary fist
   Removal and installation of a power shaft
   Removal and installation of an intermediate shaft
   Check/dismantling driving shaft/replacement of cuffs
   Bearing of a forward nave
   Back suspension bracket
   Removal and installation of a back amortization rack
   Dismantling back amortization rack/removal and shock-absorber installation / screw spring
   Cross-section levers / longitudinal lever/stabilizer
   Check of the bearing of a nave
   Removal and installation of the bearing of a nave
   Adjustment люфта nave bearing
   Removal and nave installation
   Steering
   Removal and installation of a steering wheel
   Removal and installation of a tip of steering draft
   Removal and installation of a rubber cuff of a steering drive
   Servoupravleniye pump
   Corners of installation of wheels
   Values for MAZDA 323 check
+ Brake system
+ Wheels and tires, body, car coloring, care of the car
+ electric equipment System
+ Heater, lighting system, devices
+ Governing bodies and operation receptions
+ Electric circuits




Removal and installation of a steering wheel

Removal

 PERFORMANCE ORDER

    To establish wheels in average situation. To disconnect a weight cable from the battery.

Data from memory of malfunctions of the engine or protective code of a radio receiver are thus erased. Before shutdown of the battery it is necessary to read instructions in the Section Removal and battery installation.


    To unscrew slip bolts (a key of a sound signal) on a reverse side of a steering wheel. To remove a slip.
    To turn out bolts of a steering wheel by means of a face nozzle with the extension piece.
    To remove a steering wheel a suitable stripper from a steering shaft.

Not to strike to a steering column of blows with a hammer as it because of it will develop.

Installation

 PERFORMANCE ORDER

    To check, that the lever of indexes of turn was on the average situation, differently at installation of a steering wheel the cam can be damaged. To put on a steering wheel shlitsevy connection of a shaft so that spokes settled down horizontally. To tighten a bolt of a steering wheel with effort of 40 Nanometers. To connect a cable of weight of the battery, to check work of a sound signal. To make a trial trip and at movement on a straight line to check installation of a steering wheel. Spokes of a steering wheel should settle down horizontally, otherwise respectively to rearrange a wheel. To check automatic equipment of return of the lever of indexes of turn. If are available, to establish time on hours and to set a protective code of a radio receiver.